| M43 SERIES | |
|---|---|
 |
The M43 series crystal ovens are designed to maintain crystals at a constant temperature over a wide environmental temperature range. The oven has a proportionally controlled heater circuit with fast warm-up characteristics. A spring clip provides a snug fit and good heat transfer to the HC-43 or other crystal holders listed below. Both crystal and oven are designed for thru-hole printed circuit board mounting. For more detail on the uses and limitations of crystal ovens see our application note 146-003. |
| Specification Table | |
| Parameter | M43 SERIES |
| Set Temperature | +35°C .. +95°C Customer Specified |
| Initial tolerance @ +25°C | < +/- 3°C |
| Change in Oven Cavity Temperature Versus.. | |
| Temperature (Ambient) (-30°C to Set Temperature minus 10°C)* Referenced to +25°C |
< +/- 3°C |
| Time (Warm-Up) Temperature at 2 minutes After power on @ +25°C Referenced to Temperature at 1 hour |
< +/- 1°C |
| Input Voltage (+/- 10% change) |
< +/- 0.5°C |
| Other Parameters | |
| Input Power | Customer specified voltage +5 VDC +/- 10% to +28 VDC +/- 10% <6 Watts @ turn on** -0.024 Watts/°C (zero power at Set Temperature) |
| Package | 0.75 Diameter x 0.625 inches |
| *Lower operating temperatures available. ** Custom warm-up and reduced power versions available (MS43-XXX). |
| Available Options: | Shorter height (0.575 inches) Isolated cavity versions for use with negative supply voltages. |
| Holds: HC-18/U, HC-25/U, HC-42/U, HC-43/U, HC-49/U, HC-50/U. | |
